Nano Materials

Micro Material

Lubricating Material

Alloy powder


Environmental Material

Rare Earth Material


Non-ferrous Metal

Water purification material

Bio Products

Common Chemical

Wear Resistant




wafer butterfly valve

Company News

The most suitable heat sink substrate for LED - aluminum nitride ceramic substrate

At present, with the development of LED industry at home and abroad in the direction of high efficiency, high density, high power, etc., it can be seen from 2017 to 2018 that the overall domestic LED has made rapid progress, the power is also getting bigger and bigger, and the development performance is superior. Heat dissipation materials have become a top priority for solving LED heat dissipation problems. In general, LED luminous efficiency and service life will decrease as the junction temperature increases. When the junction temperature reaches 125 °C or higher, the LED may even fail. In order to keep the LED junction temperature at a lower temperature, it is necessary to use a high thermal conductivity, low thermal resistance heat sink substrate material and a reasonable packaging process to reduce the overall package thermal resistance of the LED.
Commonly used substrate materials at this stage include Si, metal and metal alloy materials, ceramics and composite materials. Among them, the cost of Si material is high; the intrinsic conductivity of metal and metal alloy materials, the thermal expansion coefficient is not matched with the chip material; the defects of ceramic materials are difficult to process, and it is difficult to meet various performance requirements of high-power substrates at the same time.
Ceramic substrate materials are commonly found in Al2O3, aluminum nitride, SiC, BN, BeO, Si3N4, etc. Compared with other substrate materials, ceramic substrates have the following characteristics in mechanical, electrical and thermal properties:
(1) Mechanical properties. Mechanical strength, can be used as a support member; good processability, high dimensional accuracy; smooth surface, no microcracks, bending, etc.
(2) Thermal properties. The thermal conductivity is large, the coefficient of thermal expansion matches the chip materials such as Si and GaAs, and the heat resistance is good.
(3) Electrical properties. The dielectric constant is low, the dielectric loss is small, the insulation resistance and the insulation are high, and the performance is stable under high temperature and high humidity conditions, and the reliability is high.
(4) Other properties. Good chemical stability, no hygroscopicity; oil and chemical resistance; non-toxic, pollution-free, α-ray emission is small; crystal structure is stable, it is not easy to change in the temperature range of use;
Al2O3 and BeO ceramics have long been the two main substrate materials for high power packaging. However, these two substrate materials have inherent disadvantages. Al2O3 has low thermal conductivity and thermal expansion coefficient does not match the chip material. Although BeO has excellent comprehensive performance, it has high production cost and is highly toxic. Therefore, in terms of performance, cost and environmental protection, neither of these substrate materials can be used as the most ideal material for the development of high-power LED devices in the future. AlN ceramics have excellent properties such as high thermal conductivity, high strength, high electrical resistivity, low density, low dielectric constant, non-toxicity, and thermal expansion coefficient matched with Si. They will gradually replace traditional high-power LED substrate materials and become the most in the future. A ceramic substrate material with a promising future.